EXTRUSION STATION

Extrusion unit is plasticization section of the PVC formulation with a suitable extruder. PVC formula in the extruder is plasticized at required temperatures and under high pressure. Plate pattern is very important in this process, because it provides transition between the complement of the extruder and calendering.

EXTRUSION UNIT FEATURES

  • Extrusion unit control panel stores and adjusts both the extruder and the plate mold process data, as well as a stable control without fluctuation in the production process.
  • If a stable product is not supplied, this situation will have thick carvings, surface degradation, color changes and unwanted pauses in production.
  • Heat control is very important during the extrusion process. In the system where heat control cannot be provided, edge band deformations occur.
  • Degassed PVC formula, which has completed the plasticization phase in the extruder, spreads to the sheet form and becomes a film form.

EXTRUSION PROCESS PARAMETERS

Errors in the following parameters causes major problems in the design and use of the edge band. In order to avoid these problems, all machinery and equipment must complete each other correctly.

DESIGN OF EDGEBAND MOLD

Width and thickness of the edgeband are one of the most important points of attention in the furniture industry. The product cannot be used when the edgeband plate mold is not suitable for producing the desired product.

THERMAL EQUILIBRIUM OF EXTRUSION UNIT

Heat balance is one of the most important parameters for mixture not to degrade. PVC tends to slip to places where heat is high. If heat is applied to the mixture above the specified temperature, the production is faulty.

CONDUCTIVITY OF EXTRUSION SYSTEM

The uniform heat dissipation process required to prevent the mixture from being disturbed is ensured by the system being conductive.

KEEPING HEAT STABLE IN THE SYSTEM

In systems where heat balance is not stable, PVC will flow more easily to regions where heat is higher, and this situation leads to an out-of-control production.

EASY ADJUSTMENT OF MOLD JAW

Mold jaw should be easily adjusted for fast and accurate production. Difficult adjustment of the jaw may result in incorrect mold setting, and production can be faulty.

Contact us more information about Extrusion Station.

If you tell us about the range, size, and capacity of your edgeband production, we can quote you a price as soon as possible.

TOP